SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 83 (AUTOMATIC TRANSAXLE SERVICING)REMOVAL & INSTALLATIONTRANSAXLE MOUNTINSTALLATION
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Transaxle Mount: Installation

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transaxle mount to the frame. Hand start the transaxle mount bracket to transaxle bolts. Install the transaxle bracket bolts. See Figure . Start with the forward lower bolt and work clockwise to tighten the transaxle bracket bolts to specification. See TORQUE SPECIFICATIONS  .
  2. Remove the support from the transaxle. Install the transaxle bracket to the transaxle mount upper nuts. See Figure . Tighten the transaxle mount upper nuts to specification. See TORQUE SPECIFICATIONS  .
  3. Install the left engine splash shield. Install the left front tire and wheel. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.