Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radio. Refer to Radio ReplacementΒ .
  2. Remove the instrument panel storage compartment. Refer to COMPARTMENT REPLACEMENT -- IP .
  3. Remove the antenna extension cable retainers (2) from the instrument panel (1).
    Fig 1: Removing Antenna Extension Cable Retainers
    G01779785Courtesy of GENERAL MOTORS CORP.
  4. Remove the right side carpet retainer. Refer to CARPET RETAINER REPLACEMENT .
  5. Pull back the carpet in order to gain access to the antenna extension cable (2).
  6. Disconnect the antenna extension cable (2) from the main body harness (1).
  7. Remove the antenna extension cable (2) from the vehicle.
    Fig 2: Removing Antenna Extension Cable
    G01779786Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.