Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 741 (BODY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B1379: IGNITION 3 INPUT IS INACTIVETEST DESCRIPTION
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Test Description
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Test Description
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
The numbers listed below refer to the numbers on the diagnostic table.
- 4. This step determines if ignition 3 is shorted to ground.
- 5. This step determines if the BCM is internally shorted.
- 6. This step determines if the cruise control module is internally shorted.
- 7. This step determines if voltage is supplied from the battery to the fuse.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.