Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 739 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER TRANSMISSION REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Position the wiper motor to the wiper transmission.CAUTION: Refer to FASTENER NOTICE .
- Install the wiper motor screws.
Tighten
Tighten the screws to 10 N.m (89 lb in).
- Using the J 39529 , connect the wiper transmission to the wiper motor crank arm.
- Position the wiper drive system module to the vehicle.
- Install the wiper drive system module screws.
Tighten
Tighten the screws to 10 N.m (89 lb in).
- Connect the wiper motor electrical connector.
- Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.