SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 731 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT SWITCH REPLACEMENT - POWERREMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the front bucket seat to the full up position in order to gain access to the power seat switch.
  2. Pull the bezel from the power seat switch.
    Fig 1: Removing Power Seat Switch Bezel
    G01780566Courtesy of GENERAL MOTORS CORP.
  3. Adjust the front seat cushion cover in order to gain access to the power seat switch. Seat Cushion Cover Replacement - Front  .
  4. Remove the power seat switch screws.
    Fig 2: Removing Power Seat Switch Screws
    G01780567Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the power seat switch.
  6. Remove the power seat switch from the seat cushion frame.
    Fig 3: Removing Power Seat Switch
    G01780568Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.