Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully open the door.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front DoorΒ .
  3. Remove the water deflector. Refer to Window Regulator Replacement - Front DoorΒ .
  4. Remove the body-side check strap bolt.
  5. Remove the check strap plug.
  6. Remove the door-side check strap nuts.
  7. Fig 1: Door-Side Check Strap
    G01714004Courtesy of GENERAL MOTORS CORP.
  8. Pull the check strap from the inside of the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.