Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 688 (SEAT BELT SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Fastener Tightening Specifications
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Child Seat Restraint System Bracket Fasteners | 41 N.m | 30 lb ft |
| Child Tether Anchor Fastener | 30 N.m | 22 lb ft |
| Lap Retractor Fastener | 35 N.m | 26 lb ft |
| Lower Seat Belt Fastener - Rear Seat Center | 41 N.m | 30 lb ft |
| Lower Seat Belt Fastener - Rear Seat Outer | 41 N.m | 30 lb ft |
| Seat Belt Buckle Fasteners - Front Seat | 41 N.m | 30 lb ft |
| Seat Belt Buckle Fasteners - Rear Seat | 26 N.m | 19 lb ft |
| Shoulder Belt Fastener - Rear Seat Center | 41 N.m | 30 lb ft |
| Shoulder Belt Retractor Fastener - Front Seat | 35 N.m | 26 lb ft |
| Shoulder Belt Retractor Fastener - Rear Seat | 41 N.m | 30 lb ft |
| Shoulder Belt Retractor Fastener - Rear Seat Center | 30 N.m | 22 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.