SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 683 (KEYLESS ENTRY SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC SYSTEM CHECK - REMOTE KEYLESS ENTRYTEST DESCRIPTION
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Test Description

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Test Description
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
  2. 5:  The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed. Any other body control module DTCs displayed by the scan tool do not apply to Remote Keyless Entry and should be diagnosed in the applicable section.
Diagnostic System Check - Remote Keyless Entry

Step Action Yes No
1 Install a scan tool.
Does the scan tool power up?		 Go to Step 2  Go to SCAN TOOL DOES NOT POWER UP
2 
  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the following control modules.
    • body control module
    • passenger door module
Does the scan tool communicate with all of the listed control modules?		 Go to Step 3  Go to SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE
3
IMPORTANT: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  1. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool.
  2. Rotate the ignition switch through all positions while observing the ignition switch power mode parameter.
Does the ignition switch parameter reading match the ignition switch position for all switch positions?		 Go to Step 4  Go to POWER MODE MISMATCH
4 Select the display DTCs function on the scan tool.
  • body control module
  • passenger door module

Does the scan tool display any DTCs?		 Go to Step 5  Go to Symptoms - Keyless Entry 
5  Does the scan tool display any DTCs which begin with a "U"? Go to SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE Go to DIAGNOSTIC TROUBLE CODE (DTC) LIST
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.