SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 652 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSCOURTESY LAMP REPLACEMENT - INSTRUMENT PANEL - LEFTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the courtesy lamp to the opening in the closeout insulator panel (2).
  2. Push inward in order to engage the retaining clip securing the courtesy lamp to the closeout insulator panel (2).
  3. Connect the electrical connector (1) to the courtesy lamp.
    Fig 1: Installing Left Instrument Panel Courtesy Lamp
    G01802948Courtesy of GENERAL MOTORS CORP.
  4. Align the closeout insulator panel with the instrument panel retainer.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the closeout insulator fasteners (1).

    Tighten 

    Tighten the fasteners to 2 N.m (18 lb in).

    Fig 2: Installing Left Closeout Insulator Panel Fasteners
    G01802949Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.