Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 622 (ANTI-LOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSLATERAL ACCELEROMETER REPLACEMENT (W/JL4)REMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Removal Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Turn OFF the ignition.
- Remove the rear seat cushion. Refer to SEAT CUSHION REPLACEMENT -- REAR in Seats.
- Disconnect the lateral accelerometer sensor electrical connector (2).
- Remove the 2 lateral accelerometer sensor mounting screws (3).
- Remove the lateral accelerometer sensor (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.