SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 620 (CELLULAR COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSCOUPLING REPLACEMENT - ANTENNA OUTERINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean back glass with an alcohol wipe.
    2. Fig 1: Cleaning Outside Of Back Glass
    G01755150Courtesy of GENERAL MOTORS CORP.
  2. Dry the glass thoroughly using a lint free cloth.
  3. Apply Glass Adhesion Promoter GM P/N 12378555 or (Canadian P/N 88901239) to the back glass in the area where you will install the antenna coupling.

    Follow the Glass Adhesion Promoter instructions on the product label.

    Important: 

    • Align the inner and outer antenna couplings.
    • Do not touch the adhesive backing on the antenna coupling.
  4. Remove the protective film from the adhesive backing on the outer antenna coupling.
  5. Align the outer antenna coupling to the inner antenna coupling.
  6. Press firmly on all 4 corners and on the center of the antenna outer coupling (5) in order to ensure proper adhesion to the back glass (4).
    Fig 2: Identifying Outer Antenna Coupling
    G01755151Courtesy of GENERAL MOTORS CORP.

    Hold pressure on the outer coupling (5) for 10-30 seconds.

  7. Ensure that no gaps occur between the couplings (5, 2) and the back glass (4).
  8. Keep the vehicle dry. Allow 6 to 8 hours, at 15°C (60°F ), for the adhesive to cure after installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.