Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 609 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSCOURTESY LAMP/REFLECTOR REPLACEMENT - DOORREMOVAL PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door trim panel enough to access the courtesy lamp. Refer to TRIM PANEL REPLACEMENT - SIDE FRONT DOOR in Doors.
Disconnect the electrical connector from the courtesy lamp.

Fig 1: Identifying Courtesy Lamp Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Release the courtesy lamp by depressing the forward retainer.

Fig 2: Depressing Courtesy Lamp Forward Retainer
Courtesy of GENERAL MOTORS CORP.
Remove the courtesy lamp out of the front door trim panel, by pressing outward on the courtesy lamp and pulling out from the front of the door trim panel.

Fig 3: Removing Courtesy Lamp From Front Door Trim Panel
Courtesy of GENERAL MOTORS CORP.
Rotate the lamp socket counterclockwise to release the socket from the lamp housing, then remove the socket.

Fig 4: Removing Courtesy Lamp Socket
Courtesy of GENERAL MOTORS CORP.
Remove the bulb from the socket.

Fig 5: Removing Courtesy Lamp Bulb
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.