Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 585 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PRESSURE HOSE REPLACEMENT (3.8L)INSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Install the power steering pressure hose to the vehicle.
- Install the power steering pressure hose (2) to the clamps (1) on the power steering gear.
- Install the power steering pressure hose to the power steering pump.
Tighten:
Tighten the fitting to 27 N.m (20 ft lbs)
- Install the power steering pressure hose to the power steering gear.
Tighten:
Tighten the pressure hose fitting to 27 N.m (20 ft lbs)
- Install the tire and wheel assembly.
- Remove the drain pan from under the vehicle.
- Lower the vehicle.
- Install the accessory drive belt. Refer to SPECIFICATIONS & DRIVE BELT ROUTING .
- Fill the power steering system with power steering fluid. Refer to Checking and Adding Power Steering Fluid .
- Bleed the power steering system. Refer to Bleeding the Power Steering System .
- Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.