Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 545 (CHARGING SYSTEM)DIAGNOSTIC TESTSDTC P1638: PULSE WIDTH MODULATION SIGNAL OUT OF RANGECONDITIONS FOR RUNNING DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Conditions For Running DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Key ON Test
- No generator, CKP sensors, or CMP sensor DTC's are set.
- The key is in the RUN position.
- The engine is not running.
Run Test
- No generator, CKP sensors, or CMP sensor DTC's are set.
- The engine is less than 3000 RPM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.