SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 520 (CHARGING SYSTEM)ON-VEHICLE TESTINGENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECKDIAGNOSTIC PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Diagnostic Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Diagnostic Procedure
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform battery inspection test. See BATTERY TESTING & INSPECTION  under ON-VEHICLE TESTING. After inspection, go to next step.
  2. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel. Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, perform appropriate test. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
    3. NOTE: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  3. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool. Rotate the ignition switch through all positions while observing the Class 2 Power Mode parameter. The ignition switch parameter reading should match the ignition switch position for all switch positions. If reading is as specified, go to next step. If reading is not as specified, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  4. Turn ON the ignition, with the engine OFF. Attempt to communicate with each of the following modules on the class 2 serial data circuit:
    • Body Control Module (BCM).
    • Instrument Panel Cluster (IPC).
    • Powertrain Control Module (PCM).
    The scan tool should communicate with all modules on the class 2 serial data circuit. If communication is as specified, go to next step. If communication is as not specified, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  5. Select display DTC function for each module. Record all displayed DTCs, status of displayed DTCs and module that set DTC. If DTCs are displayed, go to next step. If no DTCs are displayed, repair charging system by symptom. See SYMPTOM INDEX  table under SYSTEM TESTS.
  6. If scan tool displays DTCs which begin with "U", perform appropriate test in accordance with DTC retrieved. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. If scan tool does not display DTCs which begin with "U", go to next step.
  7. If scan tool displays DTCs B1000, B1007, or B1009, perform appropriate test in accordance with DTC retrieved. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. If scan tool does not display DTCs B1000, B1004, B1007 or B1009, perform appropriate test in accordance with DTC retrieved. See DIAGNOSTIC TROUBLE CODE DEFINITIONS  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.