Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 52 (ENGINE CONTROL SYSTEM - SELF-DIAGNOSTICS - 4.2L)DIAGNOSTIC TESTSDTC P0133: HO2S CIRCUIT - SLOW RESPONSE - SENSOR 1CONDITIONS FOR RUNNING DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Conditions For Running DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0105, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0336, P0440, P0446, P0452, P0453, P0507, P0601, P0602, P0604, P0606, P1120, P1220, P1221, P1271, P1275, P1280, P1484, P1512, P1514, P1515, P1516, P1621, P1635, P1639, P1680, or P1681 are not set.
- The fuel level sensor is more than 10 percent.
- The Engine Coolant Temperature (ECT) sensor is more than 158°F (70°C).
- The engine speed is between 1450-1900 RPM.
- The loop status is closed.
- The Throttle Position (TP) indicated angle is between 25-30 percent.
- The Evaporative (EVAP) emission purge solenoid command is more than 10 percent.
- The above conditions have been met for 30 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.