Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 52 (ENGINE CONTROL SYSTEM - SELF-DIAGNOSTICS - 4.2L)DIAGNOSTIC TESTSDTC P0125: EXCESSIVE TIME TO ENTER CLOSED LOOP FUEL CONTROLCONDITIONS FOR RUNNING DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Conditions For Running DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0105, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0130, P0131, P0132, P0133, P0134, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0325, P0335, P0336, P0420, P0440, P0442, P0446, P0452, P0453, P0480, P0502 and P0503 (A/T only), P0601, P0602, P0604, P0606, P1120, P1220, P1221, P1271, P1275, P1280, P1281, P1441, P1481, P1482, P1484, P1512, P1514, P1515, P1621, P1635, and P1639 are not set.
- The engine has run more than 30 seconds and for less than 20 minutes.
- The minimum Intake Air Temperature (IAT) is more than 19°F (-7°C).
- The engine coolant temperature at start up is less than 104°F (40°C).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.