Removal & Installation

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal & Installation
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONSΒ . Disable air bag system. See ZONE 1Β  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove off-road skid plate, if equipped. Drill out rivets from applicable front end discriminating sensor. See Fig 1. Remove front end discriminating sensor.
  3. To install, reverse removal procedure. Use NEW Mounting Rivets (15715058). Ensure arrow on front end discriminating sensor is installed pointing toward front of vehicle. Activate air bag system. See ZONE 1Β  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Front End Discriminating Sensor
G98J13580Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.