SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 455 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL & INSTALLATIONPASSENGER-SIDE AIR BAG MODULE DISABLE SWITCH INDICATORREMOVAL & INSTALLATION
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal & Installation

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal & Installation
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Ensure ignition is off and key is removed. Open center console compartment door. Lift up on accessory trim plate to gain access to passenger-side disable switch indicator electrical connector. Disconnect passenger-side air bag module disable switch indicator from wiring harness connector. Use Terminal Extractor (J-35616-A) to remove LED terminals from LED connector. To install, reverse removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.