Conditions For Running DTC

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Conditions For Running DTC
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, and 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  • DTCs P0101, P0102, P0103, P0107, P0108, P0116, P0117, P0118, P0121, P0122, P0123, P0125, P0128, P0131, P0132, P0133, P0134, P0135, P0410, P0440, P0442, P0443, P0446, P0449, P1133, P1134 or P1441 are not set.
  • The vehicle is not in Park or Neutral.
  • The Engine Run Time parameter is at least 60 seconds.
  • The Loop Status parameter is closed.
  • The MAF sensor parameter is 13-30 g/s.
  • The Engine Speed parameter is 1000-3000 RPM.
  • The ECT Sensor parameter is more than 122Β°F (50Β°C).
  • The system voltage is 9-18 volts.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.