Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 367 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL METER BODY ASSEMBLY & INJECTORSREMOVAL
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Fuel Meter Body Assembly & Injectors: Removal
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Cover the injector sockets in order to prevent dirt and other contaminants from entering the open fuel passages.
- Disconnect negative battery cable. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove upper intake manifold assembly. See UPPER INTAKE MANIFOLD ASSEMBLY under AIR INDUCTION SYSTEMS.
- Before removal, clean fuel meter body assembly with a spray type engine cleaner, such as GM X-30A. DO NOT use any solvent that contains Methyl Ethyl Ketone (MEK). Solvents containing MEK may damage fuel system components.
- Label fuel injector lines for installation reference. Squeeze injector lock tabs and lift injectors from lower intake manifold. Remove fuel meter body from bracket with injector lines and injectors attached by releasing lock tabs on bracket. Disassemble as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.