Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 360 (MANUAL TRANSMISSION CLUTCHES)TORQUE SPECIFICATIONS
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Torque Specifications
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||||
|---|---|---|---|---|---|---|
| Backup Lamp Switch | 13 (17) | |||||
| Battery Cable Terminals Bolts | 13 (17) | |||||
| Battery Tray/Cooling Box Bolts | 11 (15) | |||||
| Battery Hold-Down-To-Battery Tray | 11 (13) | |||||
| Brake Master Cylinder-To-Booster Nuts | 18 (24) | |||||
| Clutch Housing Dust Cover Bolts | 18 (24) | |||||
| Clutch Master Cylinder Nuts | 17 (23) | |||||
| Drain Plug | 28 (38) | |||||
| Engine Cradle-To-Body Bolt | 140 (190) | |||||
| Engine Mount-To-Cradle Nut | 37 (50) | |||||
| Engine-To-Transaxle Bracket Bolt | 37 (50) | |||||
| Exhaust Pipe-To-Exhaust Manifold Nut | 22 (30) | |||||
| Fluid Check Plug | 28 (38) | |||||
| Flywheel-To-Crankshaft Bolt | (1) | |||||
| Front Transaxle Mount Bolts | 81 (110) | |||||
| Ground Terminal Nut | 18 (24) | |||||
| Intake Bracket-To-Intermediate Shaft Support Bolt | 22 (30) | |||||
| Pressure Plate-To-Flywheel Bolt | 18 (24) | |||||
| Stabilizer Bar Link Nut | 48 (65) | |||||
| Steering Gear-To-Column Bolt | 25 (34) | |||||
| Tie Rod End Lock Nut | 37 (50) | |||||
| Tie Rod End-To-Steering Knuckle Nut | 30 (40) | |||||
| Transaxle Mount Bolts | 37 (50) | |||||
| Transaxle-To-Engine Bolts | 55 (75) | |||||
| Wheel Lug Nut | 92 (125) | |||||
| INCH Lbs. (N.m) | ||||||
| Battery Cover Screws | 18 (2) | |||||
| Bleed screw | 62 (7) | |||||
| Clutch Actuator Cylinder Bolt | 89 (10) | |||||
| Lower Ball Joint Nut | (2) | |||||
|
||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.