Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Speed Sensor: Removal
Raise and support the vehicle. Remove the right front tire and wheel assembly. Remove the right engine splash shield. Remove the vehicle speed sensor wiring harness connector. Remove the vehicle speed sensor bolt (9). See Fig 1 . Remove the vehicle speed sensor (10) from the extension case. Remove the "O" ring (11) from the vehicle speed sensor (10). See Fig 2 . Inspect the vehicle speed sensor and "O" ring seal for the following:
- Damaged connector.
- Cracked housing.
- Signs of rotor damage.
- Cuts or nicks on the "O" ring seal (11).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.