Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel. Refer to Trim Panel Replacement - Side Front DoorΒ .
  2. Remove the water deflector. Refer to Water Deflector Replacement - Front DoorΒ .
  3. Remove the front door inner sealing strip. Refer to Sealing Strip Replacement - Front Door Window Belt InnerΒ .
  4. Remove the window to regulator bolts (2).
    Fig 1: Identifying Window-To-Regulator Bolts
    G01755895Courtesy of GENERAL MOTORS CORP.
  5. Remove the window from the door.
    Fig 2: Identifying Door Window
    G01755896Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.