Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 192 (AUTOMATIC TRANSAXLE SERVICING)REMOVAL & INSTALLATIONTRANSAXLE MOUNT ASSEMBLY (SIDE)REMOVAL
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Transaxle Mount Assembly (Side): Removal
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal
WARNING: This page is about a different car, the 2003 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and suitably support the vehicle.
- Remove the left front wheel and tire assembly.
- Remove the left front splash shield.
- Install a jackstand and a block of wood to support the transaxle.
- Remove the mount thru-bolt from the transaxle mount.
- Unscrew the rear upper mount bolt and leave in place.
- Remove the remaining 3 mount bolts.
- Remove the mount.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.