SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1908 (HYBRID CONTROLS - 3.6L (HP5) - INTRODUCTION)REPAIR INSTRUCTIONSGENERATOR CONTROL MODULE 3-PHASE CABLE ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transaxle from the vehicle. Refer to Transmission Replacement .
  2. Remove the torque dampener. Refer to Torque Dampener Removal .
  3. Remove the torque dampener and differential housing assembly. refer to Torque Dampener and Differential Housing with Fluid Pump Removal .
  4. Remove the 3 phase cable to stator bolts.
  5. Remove the cable to case retaining bolts.
  6. Remove the drive motor/generator power inverter module cable 3 phase assembly "A".
  7. Remove the case cover. Refer to Case Cover Removal .
  8. Remove the 3 phase cable to stator bolts.
  9. Remove the cable to case retaining bolts.
  10. Remove the drive motor/generator power inverter module cable 3 phase assembly "B".
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.