Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The power inverter module (PIM) temperature 1/2 sensor is used for overheat protection. The thermistor is located on the control board, near the phase U/V power MOSFET. The SGCM monitors the inverter temperature sensor for the following:
- To detect if the inverter phase U/V temperature sensor is shorted low.
- To detect if the inverter phase U/V temperature sensor is shorted high.
If one of the above conditions is detected, the MGU will set the appropriate DTC.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.