Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. From the outside of the vehicle, install the front of one side of the sunshade retainers into the sunshade track.
  2. Lower the sunshade to clear the rear brace then install the rear retainer into the track.
    Fig 1: Sunshade Panel
    G01617215Courtesy of GENERAL MOTORS CORP.
  3. While pushing in the sunshade retainers push down and position the opposite side retainers into sunshade track.
  4. Inspect the sunshade for proper operation.
  5. Install the sunroof glass panel. Refer to Sunroof Glass Panel ReplacementΒ .
    Fig 2: Sunshade Retainers
    G01617216Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.