Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1701 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH RELEASE CABLE REPLACEMENTREMOVAL PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Open the hood.
Remove the hood latch. Refer to Hood Latch Replacement .

Fig 1: Latch Release Cable

Courtesy of GENERAL MOTORS CORP.

Remove the release cable from the structure. Note the routing of the hood cable in the engine compartment for installation.

Fig 2: View Of Center Pillar Lower Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Inside the vehicle, remove the left front carpet retainer. Refer to Carpet Retainer Replacement - Front in Interior Trim.
Push carpet aside to expose release handle.

Fig 3: Hood Hinge Cable

Courtesy of GENERAL MOTORS CORP.

Pull release handle to up position.
Pry back front of handle slip to disengage from the hinge pillar.
Remove the hood hinge cable grommet from the front of the dash and remove the cable from the core support.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.