Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1681 (CELLULAR COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC SYSTEM CHECK - CELLULAR COMMUNICATIONTEST DESCRIPTION
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Test Description
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Test Description
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: Lack of communication may be due to a partial malfunction or a total malfunction of the class 2 serial data circuit. The specified procedure will determine the condition.
- 3: This step will determine which version of OnStar® is installed on the vehicle and which set of diagnostic procedures should be used.
- 4: The presence of DTCs which begin with U indicate some other system control module is not communicating.
Diagnostic System Check - Cellular Communication
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: OnStar® Schematics | |||
| 1 | Install a scan tool. Does the scan tool power up? |
Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
| 2 |
|
Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications |
| 3 |
IMPORTANT:
This vehicle will be equipped with one of two OnStar® systems, Generation 4 or Generation 5. Access the Module 2, Module I.D. Information screen on the scan tool to determine which system the vehicle is using. The coordinating diagnostic procedures should be used. Select the display DTCs function on the scan tool.Does the scan tool display any DTCs? |
Go to Step 4 | Go to OnStar Symptom Diagnosis |
| 4 | Does the scan tool display any DTCs which begin with a "U"? | Go to Step 5 | Go to Step 6 |
| 5 | Does the scan tool display DTC U1500? | Go to Diagnostic Trouble Code (DTC) List | Go to Diagnostic Trouble Code (DTC) List |
| 6 | Does the scan tool display DTC B1000, B1004, B1007, or B1009? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 7 |
| 7 | Does the scan tool display DTC B1327 or B1328? | Go to Diagnostic Trouble Code (DTC) List in Engine Electrical | Go to Diagnostic Trouble Code (DTC) List |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.