Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1637 (INTERIOR TRIM)REPAIR INSTRUCTIONSHEADLINER REPLACEMENTREMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Removal Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.
- Remove the sunshades. Refer to SUNSHADE REPLACEMENT .
- Remove the sunshade retainers (3). Refer to SUNSHADE ANCHOR REPLACEMENT .
- Disconnect the electric connectors to the rear view mirror and to the front antenna.
- Remove the power sunroof switch, if equipped. Refer to SUNROOF SWITCH REPLACEMENT in Roof.
- Remove the dome lamp, if equipped. Refer to DOME LAMP REPLACEMENT in Lighting Systems.
- Remove the assist handles. Refer to ASSIST HANDLE REPLACEMENT - FRONT and to ASSIST HANDLE REPLACEMENT - REAR .
- Remove the side upper garnish molding from the windshield. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
- Remove the upper quarter trim panels. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER UPPER .
- Pull down on the door opening weatherstrip seal on both the front and the rear doors.
- Remove the rear window trim panel. Refer to TRIM PANEL REPLACEMENT - REAR WINDOW SHELF .
- Disconnect the headliner electrical harness connector, located behind the right rear speaker.
- Disconnect the OnStar® electrical connector, if equipped.
- Disconnect the headliner electrical harness and the antenna lead, located behind the left rear speaker.
- Use J 38778 in order to remove the rear retainers (2).
- Rotate the right front seatback to a horizontal position.
- Remove the headliner (1) from the vehicle through the right front door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.