Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1618 (STEERING WHEEL AND STEERING COLUMN)REPAIR INSTRUCTIONSSHIFT LEVER REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shift lever seal (2) onto the shift lever assembly (4).NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the shift lever assembly (4) and secure it with the shift lever screw (3).
Tighten
Tighten the screw to 20 N.m (15 lb ft).
IMPORTANT: The shift lever boot must be seated inside the trim covers. - Slide the shift lever boot into the trim covers.
- Install the steering column trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.