Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1606 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL LAMP CIRCUIT BOARD REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bulbs to the tail lamp circuit board.
- Position the tail lamp circuit board to the tail lamp.
- Hold the top 2 locking tabs apart while pushing the tail lamp circuit board into place.
- Hold the bottom 4 locking tabs apart while pushing the tail lamp circuit board into place.
- Verify that the circuit board is fully seated with the locking tabs fully seated.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the 2 tail lamp circuit board retaining screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
- Install the tail lamp. Refer to Tail Lamp Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.