SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1601 (BODY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B1004DIAGNOSTIC AIDS
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Diagnostic Aids

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Diagnostic Aids
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  • This DTC may be stored as a history DTC without affecting the operation of the module. If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.
  • If this DTC is retrieved as both a current and history DTC, replace the module.
DTC B1004

Step Action Yes No
1 Did you perform the Diagnostic System Check for the system exhibiting the symptom? Go to Step 2  Go to Control Module References  for the applicable Diagnostic System Check
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Retrieve DTCs.
Is the DTC retrieved as a current DTC?		 Go to Step 3  Go to Diagnostic Aids
3
IMPORTANT: Perform the programming or setup procedure for the module if required.
Replace the control module setting the DTC as current. Refer to Control Module References .Did you complete the replacement?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.