SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1589 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENT (4.3L ENGINE)INSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cruise control module.
  2. Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement (4.3L Engine)   . 
    NOTE: Refer to FASTENER NOTICE .
  3. Install the cruise control module nuts.

    Tighten 

    Tighten the nuts to 9 N.m (80 lb in).

    Fig 1: Installing Cruise Control Module
    G01577584Courtesy of GENERAL MOTORS CORP.
  4. Connect the cruise control module electrical connector.
    Fig 2: Connecting Cruise Control Module Electrical Connector
    G01577585Courtesy of GENERAL MOTORS CORP.
  5. Install the upper fender brace.
  6. Install the upper fender brace bolts.

    Tighten

    Tighten the bolts to 9 N.m (80 lb in).

    Fig 3: Installing Upper Fender Brace
    G01577586Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.