Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1545 (CELLULAR COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSONSTAR MICROPHONE REPLACEMENTINSTALLATION PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

If installation of the mounting bracket is required, install the mounting bracket to the overhead console.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the 2 OnStar® microphone retaining screws.
Tighten: Tighten the screws to 0.8 N.m (7 lb in).
Install the microphone to the mounting bracket ensuring the quick release tab (1) is fully seated.

Fig 1: View Of OnStar Microphone Quick Release Tab
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector to the OnStar® microphone (1).

Fig 2: Identifying OnStar Microphone Components
Courtesy of GENERAL MOTORS CORP.
Install the overhead console. Refer to OVERHEAD CONSOLE REPLACEMENT--FRONT in Interior Trim.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.