Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the antenna bracket to the roof panel.
  2. Seat the antenna bracket retaining clip to the roof panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the retaining screw to the antenna bracket.

    Tighten:Β  Tighten the screw to 2.5 N.m (22 lb in).

    Fig 1: Removing/Installing Antenna Bracket In Roof Panel
    GM742198Courtesy of GENERAL MOTORS CORP.
  4. Install the headliner. Refer to HEADLINER REPLACEMENT (TRAILBLAZER EXT, ENVOY XL) or HEADLINER REPLACEMENT (TRAILBLAZER, ENVOY, BRAVADA) .
  5. Install the navigation antenna. Refer to Navigation Antenna ReplacementΒ 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.