Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger Door Module (PDM)
- Heated Seat Switch
-
The scan tool displays the status of the heated seat back and cushion switch. While the heated seat back and cushion switch is being pressed the scan tool will display Active, and when it is released the scan tool will display Inactive.
- Heat Indicator Low
-
The scan tool displays the current status of the low heat indicator.
- Heat Indicator Medium
-
The scan tool displays the current status of the medium heat indicator.
- Heat Indicator High
-
The scan tool displays the current status of the high heat indicator.
- Back Only Heat Indicator
-
The scan tool displays the current status of the heated seat back indicator.
- Back Only Heat Mode
-
The scan tool displays the status of the heated seat back switch. While the heated seat back switch is being pressed the scan tool will display Active, and when it is released the scan tool will display Inactive.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.