Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (BODY CONTROL MODULES)SELF-DIAGNOSTIC SYSTEMPOWER SEATS SYSTEM DIAGNOSTIC SYSTEM CHECK
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Power Seats System Diagnostic System Check
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Power Seats System Diagnostic System Check
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use this check as starting point for any power seats system complaint.
- Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, go to TEST D: SCAN TOOL DOES NOT POWER UP under SYSTEM TESTS.
- Turn ignition switch to RUN position. Using scan tool, attempt to establish communications with Body Control Module (BCM) and Powertrain Control Module (PCM). If communication is established, go to next step. If communication cannot be established, go to TEST C: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- Select scan tool display DTCs function for BCM. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, perform appropriate symptom. See SYSTEM TESTS in appropriate POWER SEATS article.
- Using scan tool, retrieve DTCs. If DTCs U1000-U1305 are not present, go to next step. If DTCs U1000-U1305 are present, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS . Repair as necessary.
- Check for DTC B1000 or B1339. If scan tool displays DTC B1000 or B1339, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS . Repair as necessary. If scan tool does not display DTC B1000 or B1339, go to next step.
- Check for DTC B0506. If scan tool displays DTC B0506, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS . Repair as necessary. If scan tool does not display DTC B0506, perform appropriate symptom test. See SYSTEM TESTS in appropriate POWER SEATS article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.