Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1490 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSANTENNA BUFFER REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the antenna buffer into position on the roof bow.
- Install the antenna buffer retaining screws.
Tighten: Tighten the antenna buffer retaining screws to 1.8 N.m (16 lb in).
- Connect the rear lift window antenna cable connector and the rear lift window antenna extension cable to the antenna buffer.
- Install the roof bow interior trim panel; use care to not damage the rear antenna cable. Refer to Trim Panel Replacement - Rear Roof Bow in Interior Trim.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.