SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1486 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP REPLACEMENT - REARINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Fog Lamp Bezel At Lamp Assembly
    GM95547Courtesy of GENERAL MOTORS CORP.
  1. Position the rear fog lamp assembly to the rear fascia.
  2. Install the bezel to the lamp.

    Insert the bezel into the slot on the lamp, then pivot the bezel onto the stud.

    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the rear fog lamp bezel retaining nut.

    Tighten:  Tighten the rear fog lamp bezel retaining nut to 2 N.m (18 lb in).

    4. Fig 2: Rear Fog Lamp Socket At Rear Fog Lamp Assembly
    GM95549Courtesy of GENERAL MOTORS CORP.
  4. Install the socket to the lamp.
  5. Install the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement (Europe, Japan) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.