Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1443 (HVAC SYSTEMS - GENERAL SERVICING)REPAIR INSTRUCTIONSCOMPRESSOR REPLACEMENT (LL8)REMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Removal Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
- Remove the generator. Refer to Generator Replacement (4.2L Engine) or Generator Replacement (5.3L Engine) in Engine Electrical.
- Remove the idler pulley. Refer to Drive Belt Idler Pulley Replacement in Engine Mechanical - 4.2L.
- Disconnect the compressor electrical connectors.
- Remove the compressor hose assembly bolt from the compressor.
- Remove the compressor hose assembly block from the compressor.
- Remove the compressor mounting bolts from the compressor (1).
- Remove the compressor.
- Drain and measure the compressor oil. Refer to Compressor Oil Balancing .
IMPORTANT:
Some system pressure may still exist in the A/C compressor crankcase after you evacuate the system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.