Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the overhead console in order to access the sunroof switch. Refer to Console Replacement - Overhead (TrailBlazer, Envoy, Bravada) or Console Replacement - Overhead (Envoy XUV) in Interior Trim.
  2. Fig 1: Locating Sunroof Switch Electrical Connector
    GM754906Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector from the sunroof switch.
  4. With a flat bladed tool carefully release the tabs that retain the sunroof switch to the overhead console.
  5. Fig 2: Removing Sunroof Switch From Overhead Console
    GM754903Courtesy of GENERAL MOTORS CORP.
  6. Remove the sunroof switch from the overhead console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.