Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Sunroof Switch From Overhead Console
    GM754903Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof switch alignment tabs to the slots in the console.
  2. Install the sunroof switch into the console, ensuring that the retaining tabs are fully seated.
  3. Connect the electrical connector to the sunroof switch.
  4. Install the overhead console to the roof. Refer to Console Replacement - Overhead (TrailBlazer, Envoy, Bravada) or Console Replacement - Overhead (Envoy XUV) in Interior Trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.