Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Moveable Roof Panel Seal
    GM1218491Courtesy of GENERAL MOTORS CORP.
  1. Install the locating tabs near the end of the roof panel seal to the notches in the channel of the moveable roof frame.
  2. Fig 2: Installing Moveable Roof Panel Seal
    GM1218503Courtesy of GENERAL MOTORS CORP.
  3. Press the roof panel seal down into place onto the moveable roof panel frame assembly, working from the ends of the seal towards the middle.
  4. Install the moveable roof panel. Refer to Moveable Roof Panel Assembly ReplacementΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.