Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Moveable Roof Panel Locator & Clip - Rear
    GM1218511Courtesy of GENERAL MOTORS CORP.
  1. Open the moveable roof assembly.
  2. Remove the clip (1) retaining the rear locator (2) to the moveable roof assembly, using a flat-bladed tool.
  3. Fig 2: Sliding Moveable Roof Panel Locator
    GM1349215Courtesy of GENERAL MOTORS CORP.
  4. Slide the rear locator (2) rearward.
  5. Using a flat-bladed tool, press the rear latch spring (1) forward off the retaining pin of the rear locator.
  6. Fig 3: Sliding Rear Locator To/From Tab On Moveable Roof Side Rail
    GM1218494Courtesy of GENERAL MOTORS CORP.
  7. Slide the rear locator (2) from the tab on the moveable roof side rail.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.