Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1354 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTINSTALLATION PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Upper Windshield Stoppers

Courtesy of GENERAL MOTORS CORP.

Replace the upper windshield stoppers (1) and (2).
Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .

Fig 2: Windshield Inside Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
Close the hood.
Install the rearview mirror. Refer to Rearview Mirror Replacement .
Install the windshield side garnish moldings (1). Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
Remove the double layer of masking tape from around the perimeter of the painted surfaces and the interior trim.
Close the door.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.