SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1351 (AUTOMATIC TRANSMISSION - MU5 (INTRODUCTION, SERVICE & REPLACEMENT))REPAIR INSTRUCTIONSAUTOMATIC TRANSMISSION MOUNT REPLACEMENT - FRONTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the front transaxle bracket and bolts.

    Tighten:  Tighten the transaxle bracket bolts to 64 N.m (47 lb ft).

  2. Install the insulator to the mount bracket.
  3. Install the front transaxle mount through bolt.

    Tighten:  Tighten the transaxle mount through bolt to 52 N.m (38 lb ft).

  4. Install the 2 bolts to the front transaxle mount.

    Tighten:  Tighten the front transaxle mount bolts to 39 N.m (29 lb ft).

  5. Install the left hand and right hand splash shields.
  6. Lower the vehicle.
  7. Remove the engine support fixture.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.