Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1343 (ENGINE CONTROL SYSTEM (INTRODUCTION) -- 1.8L (LNK))REPAIR INSTRUCTIONSSECONDARY AIR INJECTION (AIR) SOLENOID VALVE REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the AIR solenoid valve (2) to the intake manifold with the one fastener (1).
- Tighten the AIR solenoid valve fastener (1).
Tighten: Tighten the fastener to 8.8 N.m (77 lb in).
- Connect the vacuum hoses (3) to the secondary AIR solenoid valve (2).
- Connect the electrical connector to the AIR solenoid valve.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.