SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1343 (ENGINE CONTROL SYSTEM (INTRODUCTION) -- 1.8L (LNK))REPAIR INSTRUCTIONSHEATED OXYGEN SENSOR REPLACEMENT - POSITION 2INSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The HO2S 2 comes with an anti-seize coating on the new sensor. Take precautions in order to prevent removal of any of this coating prior to installation.
    Fig 1: HO2S 2, Wiring Pigtail And Body Plug
    GM851411Courtesy of GENERAL MOTORS CORP.
  1. Install the HO2S 2 (2) into the exhaust pipe.
    2. NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  2. Tighten the HO2S 2.

    Tighten:  Tighten the HO2S 2 to 44 N.m (32 lb ft).

  3. Install the HO2S 2 wiring pigtail and body plug (1) into the floor pan.
  4. Lower the vehicle.
    5. Fig 2: HO2S 2 Electrical Connector
    GM851413Courtesy of GENERAL MOTORS CORP.
  5. Connect the HO2S 2 electrical connector (1).
  6. Install the rear floor console. Refer to Console Replacement - Rear Floor in Instrument Panel, Gages, and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.